ASROCK P4I45PE R 3.0 DRIVER DETAILS:
|File Size:||27.3 MB|
|Supported systems:||Windows 10, 8.1, 8, 7, 2008, Vista, 2003, XP|
|Price:||Free* (*Free Registration Required)|
ASROCK P4I45PE R 3.0 DRIVER
Second] Set the system to the time that you specify. Use keys to move between the Hour, Minute and Second fields. Floppy Drives Use this to set the type of floppy drives installed.
Graphics card: PCI or AGP for an older computer with a p4i45GV MOBO Tom's Hardware Forum
Below are the configuration options. It allows user to manually enter the number of cylinders, heads, and sectors per track for the drive. Before attempting to configure a hard disk drive, make sure you have the correct configuration information supplied by the drive manufacturer. Incorrect settings may cause the system to fail to recognize the Asrock P4i45PE R 3.0 hard disk. Select [Auto] to automatically detect hard disk drive. If auto-detection is successful, the BIOS Setup automatically fills in the correct values for the remaining fields on this sub-menu. If the autodetection Asrock P4i45PE R 3.0, it may due to that the hard disk is too old or too new.
If the hard disk was already formatted on an older system, the BIOS Setup may detect incorrect parameters. In these cases, select [User] to manually enter the IDE hard disk drive parameters. This is necessary so that you can write or read data from the hard disk. Make sure to set the partition of the Primary IDE hard disk Asrock P4i45PE R 3.0 to active. Cylinders This is used to configure the number of cylinders.
Refer to the drive documentation to determine the correct value. Refer to the drive documentation to determine the correct values. Write Pre-compensation Enter Write Pre-compensation sector. Asrock P4i45PE R 3.0 This is used to configure the number of sectors per track. Maximum Capacity This field shows the drive s maximum capacity as calculated by the BIOS based on the drive information you entered. Block Mode Set the block mode to [On] will enhance hard disk performance by reading or writing more data during each transfer.
Because motherboard settings and hardware options vary, use the setup procedures in this chapter for general reference only. Refer to your OS documentation for more information. Install the necessary drivers to activate the devices Utilities Menu The Utilities Menu shows the applications software that the motherboard supports. You can find the file Asrock P4i45PE R 3.0 the following path Advanced, Security, Power, Boot, and Exit. This field should always be [Disabled] for better system stability. CPU Host Frequency: The motherboard detects the jumper setup and sets the CPU host frequency automatically.
This allows user to set CPU host frequency manually.
However, this is not recommended unless user thoroughly knows the feature. Wrong setup may cause problems during operation. Asrock P4i45PE R 3.0 Ratio Selection: Use this to set the multiple that times the frontside bus frequency must equal to the core speed of the installed processor.
If Asrock P4i45PE R 3.0 is selected, the motherboard detects the memory module s inserted and automatically assigns appropriate frequency. You can also select other value as operating frequency: Hyper Threading Technology: To enable this feature, it requires a computer system with an Intel Pentium 4 processor at 3. P4i45GV R Socket for Intel® P4 processor; Intel® GV 2Mb AMI BIOS with ACPI, SM BIOSPnP. Graphics. - Chip Int. Intel® Extreme GraphicsMissing: R.
P4i45GV R Socket for Intel® P4 processor; Intel® GV chipset 2Mb AMI BIOS with ACPI, SM BIOSPnP. Graphics. - Int.
Intel® Extreme Graphics.